How to Use General Tool v1.18

To use the General Tool v1.18, enter Service Mode first and then follow instructions bellow
(choose one of the methods you use):

Methode 1
Clear Waste Ink Counter Main
  • Select USB Port (1)
  • Device ID (2)
  • Set Destination, select printer model (3)
  • Load Paper to the printer
  • Clear waste ink counter, select MAIN (4), wait for the printer to finish printing
  • Close General Tool (5)
  • Turn off printer (wait 10 seconds)
  • Turn on printer.
  • Printer ready for use
Methode 2
Clear Waste Ink Counter Main and Platen
  • Select USB Port (1)
  • Device ID (2)
  • Set Destination, select printer model (3)
  • Load Paper to the printer
  • Clear waste ink counter, select MAIN (4), wait for the printer to finish printing
  • Clear waste ink counter, select PLATEN (5), wait for the printer to finish printing
  • Close General Tool (6)
  • Turn off printer (wait 10 seconds)
  • Turn on printer.
  • Printer ready for use
Methode 3
EEPROM Clear
  • Select USB Port (1)
  • Device ID (2)
  • Set Destination, select printer model (3)
  • Load Paper to the printer
  • Check EEPROM CLEAR (4)
  • Test Pattern 1 (5), wait for the printer to finish printing
  • Test Pattern 2 (6), wait for the printer to finish printing
  • Close General Tool (7)
  • Turn off printer (wait 10 seconds)
  • Turn on printer.
  • Printer ready for use

Download General Tool v1.18

Note:
  • MAIN reset the main waste ink counter.
  • PLATEN reset the platen waste ink counter.
  • If the main and platen waste ink absorbers are replaced reset both waste ink counters.
logoblog